PC6 Pilatus Turbo Porter車(chē)架

WARNIG: this plane is not pure 3d printed plane needs getting your hands dirty and cut foam.
This proyect born as a attempt to create a rc plane with a good performance, predictable and gentle characteristics, resistant, easy to mantain- repair, like the real counterpart the noble Pilatus Turbo Porter.
This airplane combine the foam characteristics (light, acceptable resistance, fast and easy to cut big pieces) with 3d printed qualities in critical pieces (precision, replicability and complex geometry).
The result is a easy to build airplane, lightweight but big to survive in strong winds.
AILERO and FLAP:
more info on RCGROUPS

video:
content
TP 2019 escape
TP 2019 Door Hinge
TP 2019 Fusselage Hinge
TP 2019 Motor hood front (removable)
TP 2019 motor hood back (fixed)
TP 2019 Cage Lateral 1
TP 2019 Cage Lateral 2
TP 2019 Cage Lateral 3
TP 2019 Cage Lateral 3(alternative, it needs less supports)
TP 2019 LG BASE Landing Gear Base A (Belly front)
TP 2019 LG BASE A1 Landing Gear Base separato(fusselage)
TP 2019 LG BASE Landing Gear Base B (Belly backward)
TP 2019 LG Landing gear Knee
TP 2019 LG Landing gear Shoulder
TP 2019 Motor Mount Nose ("firewall" included)
TP 2019 Nose frame lateral
TP 2019 Nose lower Front Rib
TP 2019 Nose Upper Front Rib
TP 2019 Nose lower back Rib
TP 2019 Cage front rib
TP 2019 Cage suspention
TP 2019 Cage front Wing rib
TP 2019 Cage iert tube wing -front wing lock
TP 2019 Cage rib5 backward wing lock
TP 2019 Cage rear Rib
TP 2019 Cage rib -servo suport
TP 2019 Rudder iertion piece
TP 2019 Horizontal stab union
TP 2019 WING Wing joint plug
TP 2019 teor wing fixation
TP 2019 teor fusselage fixation
TP2019 Cage base
TP2019 Wing ribs
TP2019 WINDSHIELD ADDED
TP 2019 NEW MOTOR MOUNT WITH SUPPORT
UPDATE jun 21, 2019:
I added a new motor mount with supports that could be easy to print (I didn′t printed yet). the corresponding factory file is available for simplify3d use. Basic steps are , put the object with the front over the heat bed, and explode the object in 7 support and the final piece. Print the motor mount eith 2 perimeter, 3 laye top and bottom and 100% infill, print the 7 suport part at 1perimeter and 1 or 2 laye at bottom, 0 top laye with 0% infil in the fit section (until 27mm heght) and change to 10-15% infill over this layer. Separation between supports and objects are 0,3mm). I recommend 0.2mm height.
I really appreciate that someone test this piece to