迪威網(wǎng)友499898
發(fā)布時(shí)間：2020/8/2 10:51:00
This is a mount for a 120mm or 140mm fan, to cool the self releasing "Anycubic Ultrabase" faster on a Delta / Kossel printer with 2020 extrusio.
You still need some extra 90° angles, T-nuts and bolts (i used 5mm hex bolts)
The angles are slightly off, but if you drill out the holes a bit more it should be fine
WIRING
I wired mine in the motherboard of my anycubic kossel plus, with an optocoupler-relay module in between
GCODE
my ending g-code
M400 ; let every move finish
M42 P43 S0 ; CUSTOM bed fan ON (doublecheck if the pinnumber is the same as you)
(my printer (and bedfan) shuts down automaticaly via octoprint)
my starting gcode:
M42 P43 S255 ;CUSTOM bed fan off (extra check to make sure its off before heating. Put this before everything else)
You still need some extra 90° angles, T-nuts and bolts (i used 5mm hex bolts)
The angles are slightly off, but if you drill out the holes a bit more it should be fine
WIRING
I wired mine in the motherboard of my anycubic kossel plus, with an optocoupler-relay module in between
GCODE
my ending g-code
M400 ; let every move finish
M42 P43 S0 ; CUSTOM bed fan ON (doublecheck if the pinnumber is the same as you)
(my printer (and bedfan) shuts down automaticaly via octoprint)
my starting gcode:
M42 P43 S255 ;CUSTOM bed fan off (extra check to make sure its off before heating. Put this before everything else)
|
共個(gè)文件
壓縮包大?。?46KB
|
||
|---|---|---|
微信小程序
微信掃碼打開此模型
迪威模型
微信掃碼支付