修改

文檔

圖片

迪威模型和Solidworks 聯合會員
迪威網友30b050
迪威網友30b050
原創模型

Anycubic i3 Mega-主板風扇管道2x50mm

VIP
免費,登錄即可下載
本資源不能下載
發布時間:2021/2/15 16:04:00
After the standard mainboard fan was the last noisy part in my I3 Mega after several "silent mods", I decided for the 50mm double fan veion from "mariusbach":
Why, I'll explain below (see "Why 2 x 50mm fa?")
I liked the position of the fa very much, but I wanted to focus the airflow on the stepper motor drive.
That's why I designed this air duct, which can be easily attached to the base plate. It compeates for the lateral offset of the fa and directs the air flow exactly to the cooling fi of the stepper motor drive due to the gradient at the end.
The attached snap-fit cantilever can be used. Unfortunately, these still have a little space. To avoid vibration noises during printing, I finally fixed the air duct to the base plate with double-sided adhesive tape.
Nachdem der Standard-Mainboardlüfter nach diveen "Silent Mods" das letzte laute Teil in meinem I3 Mega war, habe ich mich für die 50mm-Doppellüfter-Variante von "mariusbach" entschieden:
Warum, das erkl?re ich weiter unten (siehe "Why 2 x 50mm fa?")
Die Position der Lüfter gefiel mir schon sehr gut, aber ich wollte den Luftstrom noch etwas auf die Schrittmotor-Treiber fokussieren.
Dafür habe ich diesen Luftkanal entworfen, der sich leicht an der Bodenplatte befestigen l?sst. Er gleicht den seitlichen Veatz der Lüfter aus und leitet durch die Steigung am Ende den Luftstrom genau auf die Kühlrippen der Schrittmotor-Treiber.
Es k?nnen die angeh?ngten Snap-Fit-Bolzen benutzt werden. Diese haben aber leider noch ein wenig Spiel. Damit dort beim Drucken keine Vibratioger?usche entstehen, habe ich meinen Luftkanal letztendlich mit doppelseitigem Klebeband an der Bodenplatte festgeklebt.
Used Fa / verwendete Lüfter:
Noiseblocker XS-1 BlackSilentFan
個文件
壓縮包大小:2MB
小程序二維碼
微信小程序 微信掃碼打開此模型
登錄后發表評論
恒諾鑫科-專注碳素制品的開發與生產