迪威網(wǎng)友c8cb44
發(fā)布時間：2021/1/11 2:54:00
Update 03.04.20 - Uploaded V2 of Right Hand Plate. Fit one was a duplicate of the left and not a mirror.
This is an armor set remixed from a Pepakura armor files uploaded by Art Andrews on the forum. The files I made printable are:
1) Modeller: ForgedReclaimer
2) Modeller: Bungie Unfolder: fat-hi555
3) Smoothed, Edited and Unfolded: koshima07
4) Modeller: Unknown Unfolder: ErMac Foam Unfolder: WandererTJ
5) Modeller: WandererTJ
6) Modeler: rundown Unfolder: @BMcClain
7) Modeller: ForgedReclaimer
8) Modeller: RoadWarrior
3 things to note:
1) It is currently scaled to 5'10" 185lb peon.
2) It is not split up into smaller print files. I may do this later.
3) The thighs are difficult to put to scale so I left them close. I would not use them in their current state unless they were seriously modded after print.
The reason for uploading the armor set like this is that it gives the end-user a chance to resize the armor to their body and split it up to their 3d print bed.
This is an armor set remixed from a Pepakura armor files uploaded by Art Andrews on the forum. The files I made printable are:
1) Modeller: ForgedReclaimer
2) Modeller: Bungie Unfolder: fat-hi555
3) Smoothed, Edited and Unfolded: koshima07
4) Modeller: Unknown Unfolder: ErMac Foam Unfolder: WandererTJ
5) Modeller: WandererTJ
6) Modeler: rundown Unfolder: @BMcClain
7) Modeller: ForgedReclaimer
8) Modeller: RoadWarrior
3 things to note:
1) It is currently scaled to 5'10" 185lb peon.
2) It is not split up into smaller print files. I may do this later.
3) The thighs are difficult to put to scale so I left them close. I would not use them in their current state unless they were seriously modded after print.
The reason for uploading the armor set like this is that it gives the end-user a chance to resize the armor to their body and split it up to their 3d print bed.
|
共個文件
壓縮包大?。?4MB
|
||
|---|---|---|
微信小程序
微信掃碼打開此模型
迪威模型
微信掃碼支付