迪威網(wǎng)友b3c350
發(fā)布時(shí)間：2020/12/22 21:47:00
This is a block to take up the gap in the center skid plate for the Redcat Gen 8 International Harvester Scout II scale crawler. Due to the part having a void for the molding process, lock nuts are used from the factory to help keep the rear upper link screws from loosening up. This lock nut block fills the void, and helps keep the screw in place without having to use a lock nut.
Additional hardware needed:
2pcs: M3x25mm button head
To itall, remove the upper and lower link screws to get the links out of the way. Now iert the block into the void from the bottom of the skid plate, and reitall both links and screws. For best results, using M3x25mm screws going into the lock nut block is recommended.
Redcat parts on Thingivee are released under the Creative Commo Licee Attribution- NonCommercial- ShareAlike 4.0 International (CC BY-NC-SA 4.0).
We want to share these parts with the world, and we want to ipire people to make and share their own parts for their vehicles.
In keeping with the non-commercial clause of this licee, if you produce this part (Gen 8 Center Skid Plate Lock Nut ) for othe, you may not receive compeation in excess of $0.50 per part, plus your shipping costs. This number is calculated based on an average estimate of material cost and machine running costs.
Additional hardware needed:
2pcs: M3x25mm button head
To itall, remove the upper and lower link screws to get the links out of the way. Now iert the block into the void from the bottom of the skid plate, and reitall both links and screws. For best results, using M3x25mm screws going into the lock nut block is recommended.
Redcat parts on Thingivee are released under the Creative Commo Licee Attribution- NonCommercial- ShareAlike 4.0 International (CC BY-NC-SA 4.0).
We want to share these parts with the world, and we want to ipire people to make and share their own parts for their vehicles.
In keeping with the non-commercial clause of this licee, if you produce this part (Gen 8 Center Skid Plate Lock Nut ) for othe, you may not receive compeation in excess of $0.50 per part, plus your shipping costs. This number is calculated based on an average estimate of material cost and machine running costs.
|
共個(gè)文件
壓縮包大小：120KB
|
||
|---|---|---|
微信小程序
微信掃碼打開此模型
迪威模型
微信掃碼支付