3M Mask Respirator Filter Adapter Voice Module防毒面具 傳聲模塊 通話器 濾棉承接盒

Yond原創模型，免費分享 | CC BY-NC-ND 適合 3M 6000, 6500, 6800和7500系列的面具. 特性：高度還原3M面罩的卡口設計、方向性設計、對稱設計、防噴濺設計、方便安裝和FDM打印等等 本模型可以作為傳聲模塊使用，也可以作為應急濾盒使用： 1.傳聲模塊模式：使用厚度0.1mm-0.3mm、直徑50mm的圓形振膜，目前公測振膜材料，可以嘗試PET、PU、丁基橡膠、金屬等；硬質材料請?zhí)砑?.5mm-1mm厚的密封墊圈來保證氣密性；傳聲模塊模式下可以把進氣閥門取下來以獲得更好的效果。 2.濾盒模式：使用直徑50mm圓形濾紙放入其中壓緊即可。你可以做負壓氣密性檢查，用手掌蓋住開口后輕輕吸氣。最后再蓋上防護罩。 ▲警告▲ 本模型沒有經過任何專業機構的測試和認證。 雖然我打的模型有良好的氣密性，但每個人的情況可能不一樣，你要對自己的情況負責。 記得每次戴上面罩前都要進行氣密性檢查。 Original model by Yond, no charge | CC BY-NC-ND Designed for 3M 6000, 6500, 6800 and 7500 series respirato. Features：Finely built bayonet structure from 3M reusable respirator, direction design, symmetrical design, anti-splash design, easy assembly, friendly with FDM printe. This model can be used as a voice module or as an emergency filter adapter↓ Mode 1→Voice Moduleound tramission module Cut a circular diaphragm with a thickness of 0.1mm-0.3mm and a diameter of 50mm, use a seal gasket (0.5mm-1mm thick) if you choose a hard material as a diaphragm. Currently, the diaphragm material is under public testing. Peonally, I tested 0.3mm PET and 0.1mm PU, both are not so ideal, so you can try things like rubber film, thinner plastic film, etc. You can remove the inhale valve to get better performance. Mode 2→Filter Adapter mode Put iide a piece of circular filter material with the diameter of 50mm and finish the itallment. You can perform a negative pressure user seal check by covering the opening using palm of your hand and then inhale gently. Put on the protection cover afterwards. △CAUTION△ △This design is NOT tested and certified by any professional authorities. △Even though I tested very good air tight sealing, it can be different in your situation when it comes to print and itall, you are respoible for your own case. △Remember to do a user seal check every time you put on your respirator.