迪威網(wǎng)友2dff6f
發(fā)布時間：2020/4/26 12:27:00
Hello Everyone!
Recently I bought Raspberry Pi 4B 2GB as a remote control for Anycubic I3 Mega using Octoprint for it.
I didn't placed this computer iide 3D Printer because I wanted to have possibility to plug and unplug Raspberry whenever I need.
Fitly I printed case for Raspberry from this link. This case was designed by Harryb1991 and I choose the one without special hole for a fan (I bought aluminium radiator but not yet place on board).
Raspberry Pi, even in it's own case, still didn't have it's own place around the printer. I had to do something with this. I wanted do something that allows me to plug and unplug whole case with this tiny computer everytime when I needed.
I looked around the right side of the printer and I choose a right "arm" where right motor is placed. There was a two screws with 45mm separation between them. I decided to use this screws.
I designed a holder which allows me to place Raspberry Pi on this "arm".
I used Fusion 360 for design this part.
I also made another one which looks more solid and modern. I didn't print this, I didn't test it and I didn't check is everything right designed. If you want print, you are making this on your own risk ;)
I attached Fusion 360 model for free. I saved the models in this exteio: .stl, .iges, .sat, .smt, .step, .obj, .skp, .ipt
Feel free to modify them whatever you want.
Recently I bought Raspberry Pi 4B 2GB as a remote control for Anycubic I3 Mega using Octoprint for it.
I didn't placed this computer iide 3D Printer because I wanted to have possibility to plug and unplug Raspberry whenever I need.
Fitly I printed case for Raspberry from this link. This case was designed by Harryb1991 and I choose the one without special hole for a fan (I bought aluminium radiator but not yet place on board).
Raspberry Pi, even in it's own case, still didn't have it's own place around the printer. I had to do something with this. I wanted do something that allows me to plug and unplug whole case with this tiny computer everytime when I needed.
I looked around the right side of the printer and I choose a right "arm" where right motor is placed. There was a two screws with 45mm separation between them. I decided to use this screws.
I designed a holder which allows me to place Raspberry Pi on this "arm".
I used Fusion 360 for design this part.
I also made another one which looks more solid and modern. I didn't print this, I didn't test it and I didn't check is everything right designed. If you want print, you are making this on your own risk ;)
I attached Fusion 360 model for free. I saved the models in this exteio: .stl, .iges, .sat, .smt, .step, .obj, .skp, .ipt
Feel free to modify them whatever you want.
|
共個文件
壓縮包大?。?MB
|
||
|---|---|---|
微信小程序
微信掃碼打開此模型
迪威模型
微信掃碼支付