7英寸HDMI液晶盒

(Update 3/8/2019)A new veion is posted here
(Update 1/21/2019) Added a desktop foot.
A case for7-inch HDMI/VGA LCD module
that can take up to 1920x1080 resolution (with auto scaling - the native resolution is 1280x800).
This case supports VESA 75mm/100mm mount. Most monitor arms should just work.
Upside-down mount is supported for the button part.
These 3 files are minimum requirement for assembling this case:
lcd3 back backside
lcd3 front frontside
lcdhid1 butto box (with IR receiver)
Other files are various mounting optio (hooks and legs). You may or may not need them depending on your scenario.
lcdfoot2 A foot for desktop standing mount.
lcdfoot3 A foot for desktop 60-degree angled mount.
lcdfoot6 Same as above, but much slimmer veion.
lcdhook1 A hook for hanging, but maybe specific to this chest.
There is a support for RPi Zero, too, with easy access from the outside by removing that part of the wall along the cuts. RPi3 Model A can be mounted too, but a lot of creativity would be required.
Assembly requires some screws.
Driver board – 4x M2, M3, or #4 wood screw (example)
Mounting brackets – Some M4 or #6 machine screws (example)
（更新2019/3/8）新版本已公開
（更新2019/1/21）增加了放桌子用的腿。
7英寸HDMI/VGA LCD模塊
是專用的箱子。這個模塊是本地分辨率1280x800，但可以輸入1920x1080（自動縮放）。
該情況對應于VEESA 75mm/100mm掛載。我想大部分的監視器臂都能使用。
也適用于上下顛倒安裝。按鈕部分可以顛倒。
組裝箱子需要以下3個文件。
背面3
lcd3front前面
Icdhid1按鈕和IR受光部
其他文件是安裝用的掛鉤和腳。請根據需要打印。
直立放置的腿
為了在3臺上以60度的角度放置的腿
同上，細版本
從架子上吊的掛鉤，但是要根據架子的尺寸
可內置RPi Zero。如果您可以將一部分的引腳從墻外切入。雖然RPi3 Model A也可以內置，但是難度很高。
組裝所需的螺絲：
驅動器板4xM2/M3/#4（例）
安裝用掛載為M4（例）