動畫眼機制 V2

Video:
Animatronic eyes using 4 9G servos. Builds from my last design by adding a second eye and eyelids.
How to build it
You need:
8 M3x5 screws
8 M3x7 screws
4 micro servos
Wire (like a paperclip) or 2 small screws
Shrinkwrap
Your favorite RC receiver, servo controller, or microcontroller
Printing:
Print 2 of and eye_mount.stl - you need to mirror one copy left-to-right
Print 1 of everything else
Print with the flat part on the print bed.
eye_mount.stl should be printed sideways, with the flat side down, as should eye_top, eye_bottom, eye_top_lever, and eye_bottom_lever.
eye_servo_plate should be printed as is.
most of the other links should be flipped 180* before printing.
Assembly:
Center all your servos, then attach single-sided servo hor to two of them. Depending on the brand, you may need to clip off the last 5mm or so to get them to fit. Then itall your servos with their included mounting screws. Use just 1 screw for the two servos that lay on their side since we'll use the other screws for holding on the eye mounts, which can be italled now. Then start assembling the linkages toward the front and work your way back. Use 7mm screws to hold the cross-links onto the servo hor, and 5mm for everything else. Once all the parts are in place, use ~1 cm long strips of shrinkwrap to attach the links to the eyes and eyelids. Shrink them with a soldering iron, just be careful not to destroy the parts themselves!