迪威網(wǎng)友732614
發(fā)布時間：2021/1/7 5:18:00
Air compressor silencer for the loud Husky model 0300816.
This worked so well that I wanted to share.
The noise level went from "Maybe I should have hearing protection" to "Not bad at all".
I just printed it in PLA and sprayed the exterior with some rubberized undercoating, if it melts in the summer then I'll try PETG.
Fill the tube loosely with fiber material and push it onto the original intake filter.
Use some alcohol on the filter's rubber seal to help it slide on nicely.
The ID is 66mm.
No Supports needed.
Thanks
This worked so well that I wanted to share.
The noise level went from "Maybe I should have hearing protection" to "Not bad at all".
I just printed it in PLA and sprayed the exterior with some rubberized undercoating, if it melts in the summer then I'll try PETG.
Fill the tube loosely with fiber material and push it onto the original intake filter.
Use some alcohol on the filter's rubber seal to help it slide on nicely.
The ID is 66mm.
No Supports needed.
Thanks
|
共個文件
壓縮包大?。?79KB
|
||
|---|---|---|
微信小程序
微信掃碼打開此模型
迪威模型
微信掃碼支付