迪威網友6900a8
發布時間：2021/3/13 6:28:00
A BASE. Please use M3*8 bolts, spring washe and hex nuts to fix rails to the base, to make the system portable. IPT included.
HIGHER VEIO OF ALL 3 CARTRIDGES. Heights increased by 5mm. SLDPRT included.
CARTRIDGE PRINTING DIRECTIO
Print flat. No support. Fan on high. Solid infill. Finest settings. Clean up with xacto knife.
Manual Feede: The Complete System is printable on a 200*200 format. Split models as needed.
Do not tighten the rail screws with excessive force. Otherwise you may squash or crack prints. Did I mention spring washe?
Use pre cut sticke to label. You can buy those in sheets of 500. If you have a label maker, that's fine.
Credits to the awesome people who published the original models.
FURTHER WORK NEEDED Improve the fitting.
HIGHER VEIO OF ALL 3 CARTRIDGES. Heights increased by 5mm. SLDPRT included.
CARTRIDGE PRINTING DIRECTIO
Print flat. No support. Fan on high. Solid infill. Finest settings. Clean up with xacto knife.
Manual Feede: The Complete System is printable on a 200*200 format. Split models as needed.
Do not tighten the rail screws with excessive force. Otherwise you may squash or crack prints. Did I mention spring washe?
Use pre cut sticke to label. You can buy those in sheets of 500. If you have a label maker, that's fine.
Credits to the awesome people who published the original models.
FURTHER WORK NEEDED Improve the fitting.
|
共個文件
壓縮包大小：6MB
|
||
|---|---|---|
微信小程序
微信掃碼打開此模型
迪威模型
微信掃碼支付