Ender 3Ender 3 Pro極簡主義Z型線纜支持和指南

Minimalist support post and cable guide to hold the ribbon and hotend cables in order to avoid cables snagging. This design holds and hides as much cable as possible keeping full Z axis movement without skimming over any part.
This design is ipired by the previous Daz68'cable support design:
The cable clip is ipired by the nastyninjabear' design:
Note that you need two short M4 fastene to itall the pillar. I used the leftover T-nuts and bolts of the Ender 3 Pro mounting. Also, you should divide the ribbon cable into two parts (E motor and X motoeor) to have a narrower cable. Put them one on top of the other iide the pipeline.