迪威網(wǎng)友1ba039
發(fā)布時(shí)間：2020/4/19 14:41:00
This is a work in progress! I have finished printing the pieces and will begin assembly and photographing them soon.
4.15.20 - All four pieces have successfully printed.
4.13.20 - Successfully printed Right case with logo.
4.13.20 - Smoothed out front of Right Case without logo, uploaded revision 2.
4.12.20 - Discovered error with logo on Right Case during initial print, uploaded revision 2.
4.12.20 - Successfully printed Left case with Logo & 30A Relay.
4.12.20 - Swapped one of the 10A relays for a 30A relay on left case with logo.
4.11.20 - Uploaded cases with logos, cleaned up front surface.
This is made of many, many different parts from a lot of people. I sincerely appreciate everyone's work, I basically just cut and pasted it all together.
I have two 30mm fa from a previous Raspberry Pi case, so I added them to the cover over the mainboard.
I couldn't manage to fit both a relay and a buck converter in the original left side bin and still be able to access the HDMI and micro USB ports.
This remix allows for two buck converte on the right side and two relays on the left side, with as much space as is available for HDMI and micro USB.
The fan cove are here:
Full model:
Left case, no logo, 2 10A relays:
Left case, no logo, 1 10A relay and 1 30A relay:
Left case, logo, 1 10A relay and 1 30A relay:
Right case, no logo:
Right case, logo:
4.15.20 - All four pieces have successfully printed.
4.13.20 - Successfully printed Right case with logo.
4.13.20 - Smoothed out front of Right Case without logo, uploaded revision 2.
4.12.20 - Discovered error with logo on Right Case during initial print, uploaded revision 2.
4.12.20 - Successfully printed Left case with Logo & 30A Relay.
4.12.20 - Swapped one of the 10A relays for a 30A relay on left case with logo.
4.11.20 - Uploaded cases with logos, cleaned up front surface.
This is made of many, many different parts from a lot of people. I sincerely appreciate everyone's work, I basically just cut and pasted it all together.
I have two 30mm fa from a previous Raspberry Pi case, so I added them to the cover over the mainboard.
I couldn't manage to fit both a relay and a buck converter in the original left side bin and still be able to access the HDMI and micro USB ports.
This remix allows for two buck converte on the right side and two relays on the left side, with as much space as is available for HDMI and micro USB.
The fan cove are here:
Full model:
Left case, no logo, 2 10A relays:
Left case, no logo, 1 10A relay and 1 30A relay:
Left case, logo, 1 10A relay and 1 30A relay:
Right case, no logo:
Right case, logo:
|
共個(gè)文件
壓縮包大小：3MB
|
||
|---|---|---|
微信小程序
微信掃碼打開此模型
迪威模型
微信掃碼支付