迪威網友5cf6e8
發(fā)布時間：2021/3/16 1:08:00
Cover for TT's PSU. Links to the components above. Design ipired by the many other variatio on Thingivee, but made from scratch.
You will need:
3x XT60 connecto (
1x three pin IEC320 C14 Module Plug with switch (
1x Snap-in mini switch for lights or whatever you want to use it for (
-2x M3 bolts (3-4mm long), 2x M3 nuts and 1 10-15mm long M3 bolt to hold the cover in place.
ITRUCTIO:
1) The 3 pin plug needs two M3 screws of at least 3-4 mm long and 2 nuts. I used some from this box:
2) The slot for the TX60 connecto is tight enough to hold them in place but just in case I superglued them to the walls.
3) The mini switch snaps in place.
4) to hold the cover in place screw the 10-15mm M3 screw through the hole on the right wall onto the hole on the PSU.
I hope I made it clear. I'll try to awer questio.
I'll leave an .STP file so you can modify if you wish to.
You will need:
3x XT60 connecto (
1x three pin IEC320 C14 Module Plug with switch (
1x Snap-in mini switch for lights or whatever you want to use it for (
-2x M3 bolts (3-4mm long), 2x M3 nuts and 1 10-15mm long M3 bolt to hold the cover in place.
ITRUCTIO:
1) The 3 pin plug needs two M3 screws of at least 3-4 mm long and 2 nuts. I used some from this box:
2) The slot for the TX60 connecto is tight enough to hold them in place but just in case I superglued them to the walls.
3) The mini switch snaps in place.
4) to hold the cover in place screw the 10-15mm M3 screw through the hole on the right wall onto the hole on the PSU.
I hope I made it clear. I'll try to awer questio.
I'll leave an .STP file so you can modify if you wish to.
|
共個文件
壓縮包大?。?72KB
|
||
|---|---|---|
微信小程序
微信掃碼打開此模型
迪威模型
微信掃碼支付