托尼斯塔克熱棒的RC修正

Sadly but original project was deleted from this site by author after I started this modification.
There are I posted ONLY modified parts and some made by myself. If you have not printed Tony Stark hotrod or original files, you can find author - MACONE1 and ask him.
It has a RWD with simple gea and solid axle. Gea ratio is a 5:1, its not enough for power, motor works with overload and goes to heat and melting pinion.
I made some modification for backside and added motor's mount.
Reworked rear_rail and added mount for 625zz bearing, it part need to print one with one mirrored.
Splited boot for easy printing and adding door.
Splited floor for printing on small bed.
Made mount for 380 motor which can slide front-back for tune. Its mounts on rear rails by M3 screws.
Edited steer for servo which glued on backside of radiator. On tub added hole for M3 screw which keep wheel, it part same for the left and right sides.
Spacer glued on front side of radiator and add some space beetween front griill and steer.
Wheeldrive glued on the inner side of rear wheels and drive them by M5 nut. Rear wheels, bearings and big gear mounts on M5 threaded rod by M5 nuts and lock-nuts.
Small gear puts on motor's axle with M3 nut and screw.