迪威網(wǎng)友44bc54
發(fā)布時(shí)間：2021/1/5 17:10:00
This is a very tight holder for a flashlight like the one found at this link:
This allows the OneWheel far better night-riding capabilities, as illustrated in the last two images. The third (darker) image is without this light turned on, and the fourth (brighter) image is with the light attached. Since my particular light also has a built-in USB battery bank, it can be used for charging your phone in a pinch as well.
It attaches at the bottom of the OneWheel XR, where LandSurf Fangs attach. In fact, I am using this with LandSurf Fangs 2.1. It could also be used without fangs. It rides slightly (2-3mm) above the footpad as seen in the second image, so that it won't trigger the pressure seo. I put a piece of hook velcro under the mount so that, if the mount is bumped, it would not scratch my griptape.
I wrote "Saniel Dimone" in big text across the front of mine (it is my name with the fit two initials reveed, as a joke). Feel free to cancel them out in with a 0.75mm extrusion in Fusion 360 or any other application. If there is enough interest, I can even do this myself. Write me a message if interested.
This allows the OneWheel far better night-riding capabilities, as illustrated in the last two images. The third (darker) image is without this light turned on, and the fourth (brighter) image is with the light attached. Since my particular light also has a built-in USB battery bank, it can be used for charging your phone in a pinch as well.
It attaches at the bottom of the OneWheel XR, where LandSurf Fangs attach. In fact, I am using this with LandSurf Fangs 2.1. It could also be used without fangs. It rides slightly (2-3mm) above the footpad as seen in the second image, so that it won't trigger the pressure seo. I put a piece of hook velcro under the mount so that, if the mount is bumped, it would not scratch my griptape.
I wrote "Saniel Dimone" in big text across the front of mine (it is my name with the fit two initials reveed, as a joke). Feel free to cancel them out in with a 0.75mm extrusion in Fusion 360 or any other application. If there is enough interest, I can even do this myself. Write me a message if interested.
|
共個(gè)文件
壓縮包大?。?43KB
|
||
|---|---|---|
微信小程序
微信掃碼打開此模型
迪威模型
微信掃碼支付