JBL夾子3拉鏈固定架

This is a zip tie assisted bike mount for the JBL Clip 3.
Currently works on bikes with a flat top tube, will probably upgrade later to fit common round top tubes.
Demo video -
Works great as a general-purpose mount for the clip 3 as you can zip tie it to anything.
Ipired by this video from Reddit -
Couldn't find the file anywhere, OP didn't share it in the comments, so I went and made my own.
Supports are recommended, at an angle of 33 degrees.
I use support blocke in Cura in order to make sure there are no supports on the zip tie and button holes, although it is usually not a problem removing these supports.
Managed to print it on a stock Ender-3 without supports at 0.3 layer height and speed of 100 mm, but for the best results, supports are recommended.
Currently, the zip tie holes are very thin at the bottom (around 1mm). It does hold on, but I will make them thicker for a more fail-proof design.
**The model exports 90 degrees sideways, I now rotate it in the slicer until I will find the reason...